Honeywell GmbH 16 MU5H-1419GE23 R0815
9.1.3. Reserve history
The display shows RESERVE HISTORY.
Reserve history (at the time of regeneration):
3. Push to exit the settings.
The display shows TIME OF DAY or another general para-
meter (see 8.1. General parameters).
9.2. Flow rate
The display shows MAX FLOW.
The display shows the maximum flow rate of the last 7 days.
1. Push and hold for 5 seconds both buttons and
to reset the flow rate.
2. Push to exit the settings.
The display shows TIME OF DAY or another general para-
meter (see 8.1. General parameters).
9.3. Regeneration data
1. Push and hold twice for 3 seconds both buttons
and .
The display shows TOTAL DAYS - the total number of days
since start up.
2. Push to go to the next parameter.
The display shows TOTAL REGENS - the total number of
regenerations since start up.
3. Push to go to the next parameter
The display shows TOTAL CUBIC METERS - the total
amount of used water in m³ since the start up. -
9.4. Error log
1. Push to go to the next parameter.
The display shows ERROR LOG. .
The error log includes the last 10 errors generated by the
controller.
2. Push or to scroll through the list of 10.
3. Push to exit the settings.
The display shows TIME OF DAY or another general para-
meter (see 8.1. General parameters).
10. Maintenance
The completed maintenance work needs to be documented in
the “Maintenance log” on page 18.
10.1.Preparation
1. Shut down water inlet
2. Unplug the KS20S softener
3. Drain the installation by opening the taps at the highest
and the lowest level of your house.
Day 0
Day 1
Day 2
:
Day 6
Today
Yesterday
The day before yesterday
:
(max)
Note! Not visible in time mode, when the volume
setting is 0. The function day override triggers the rege-
neration.
Note! "R" is displayed if regeneration has occured in
the last 24 hours.
Note! Only available when controller is switched on.
To Next Page
Loading...
Need help?
General
