Honeywell L5200 Series User Manual

– 28 –
SECURING THE PREMISES
Bypassing Protection Zones
Bypassing Individual Zones
The Bypass feature can be used when you want to intentionally arm your system with one or more zones
unprotected. Bypassed zones are unprotected and will not cause an alarm when violated while your system is
armed. All bypasses are removed when an Off sequence is performed. The system will not allow
Panic, Fire or CO zones to be bypassed.
Bypassing Zones
Not Ready To Arm - Fault
5200-100-026-V0
Delay
Phone
More
Message
Zones
Fault 2
Front Door
10:18 AM June 8, 2010
System
1. With the system in the disarmed state, select the “Zones”
icon. The system displays the Zones/Bypass screen.
Not Ready To Arm - Fault
5200-027-027-V0
2. Front
Door
Select
Fault
FAULT
Bypass All
Faulted
Bypass
Clear
Bypasses
2. Select the zone(s) that you wish to bypass and then select
“Bypass” OR if programmed, the “Bypass All Faulted” button
allows you to bypass all faulted zones (excluding Panic, Fire
or CO zones). The system displays a keypad.
Not Ready to Arm - Fault
Bypass Selected Zones
Enter Code:
Cancel
5200-100-083-V0
2 31
5
64
0
8
97
Clear
3. Enter a valid Code. The system returns to the Bypass screen
and the zone(s) that are bypassed will be displayed.
4. Select the  icon to return to the Security Screen.
5. Arm the system normally. See Arming the System section for
the procedure.

Honeywell L5200 Series Specifications

General

Brand	Honeywell
Model	L5200 Series
Category	Security System
Language	English