Honeywell LTE-X series User Manual

LTE-X Series Installation and Setup Guide
– 18 –
Central Station Messages
The following messages are sent to the Central Station by AlarmNet for the conditions listed below. NOTE: The control
panel sends its own general code (E353) for a trouble condition.
Alarm Condition
Alarm Code
Restore Code
Power On / Reset (xx=device address)
E339 C08xx
ECP Supervision E355 C0000 R355 C0000
Communication Path Supervision
R350 C0951
Test
5555 5555 9
Status Application Code Update
E903
R903
Application Code Update Fail E904
Module Firmware Update
E365
R365 (success)
Module Firmware update Fail
E366
Glossary
4G LTE
Refers to the fourth generation Long Term Evolution cellular
wireless standards.
AES
Advanced Encryption Standard
CRC
Cyclic Redundancy Check used to confirm validity of MAC ID.
ECP
Enhanced Console Protocol, is a proprietary bus used in
Honeywell control panels to communicate with keypads and
peripheral devices. It uses four wires; power, ground, data in,
data out.
IMEI
International Mobile Equipment Identity number.
LRR Long Range Radio, an older term now referred to as
communicator. A broader term communications module or
communications device may also be used.
MAC ID
Media Access Code, this is a unique address assigned to every
network communications device. Typically it is located on the
communicator label, and on the box.

Honeywell LTE-X series Specifications

General

Brand	Honeywell
Model	LTE-X series
Category	Cell Phone
Language	English