Honeywell Magic Stat MS3000 User Manual

PROGRAMMING YOUR THERMOSTAT
You may program this thermostat either before or after installation. See installation manual
form number 69-8025 for installation instructions.
If you are programming the thermostat before installation,
be sure the battery is installed (see
page 4). During programming, if you leave the thermostat for a few minutes, it will go blank to
save battery power. This does not affect your program;
hold HEAT key to relight the
display.
STEP 1
SET THE PROGRAM SCHEDULE AND TEMPERATURES
Before you begin... The schedule form on page 31 provides an opportunity to plan your
schedule. Please fill it out before you begin.
On Off
Open right-hand door of thermostat. Switch to OFF to clear the thermostat.
Power
5
69-8026—2
On Off
Switch ON. The display shows this test position.
=
60 70 80 90
1111111111111111111
3
mmmmmmmm mmmmmmmmmmm
18:80 :y&kyMK
AM PM ~~};~nL
■ ■ ■ ■ ■ ■ ■
SMTWTFS
A few seconds later, the display looks like this.
60 70 80 90
1111111111111111111
3
■ mmmmn
70
Y
■ mmmnmm
SMTWTFS
z~
ROOM TEMPERATURE OISPLAYEO
6
-—-
To begin programming, press and hold until the
display looks like this. If you pass this display,
‘ode continue to hold key until this display comes back.
NOTE: All seven day indicators are onto tell you that
you are programming every day of the week the
same. You will be able to change individual days
later.
To set the first time program, press and hold until
the display shows the time you want to wake up
(6:00
“o
w
AM shown).
The time advances in 30-minute intervals. You can
back up by tapping the key; go forward by holding the
key.
60 70 80 90
~1111 ,1111,11,1,11111
12:00 PROGRAM
AM
60 70 80 90
,1,1,,,,1,,,,1,,,,1
n
6:00 PROGRAM
AM
■ ■ ■ ■ ■ ■ ■
SMTWTFS
69-8026—2

Honeywell Magic Stat MS3000 Specifications

General

Brand	Honeywell
Model	Magic Stat MS3000
Category	Thermostat
Language	English