Honeywell MS3780 Fusion - Page 39

MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021 Page 39
Scanning Items
Scanning Items
After the scanner has been programmed and configured properly, scan the items as follows:
If the CodeGate button is DISABLED (“Sheet 18” on page 37 was scanned during the scanner
setup), items will be scanned as follows:
With the scanner in or out of its stand, pass the item to be scanned within 11 inches of the scan
window. The scanner will read the barcode of the item.
If the CodeGate button is ENABLED (“Sheet 18” on page 37 was NOT scanned during the
scanner setup), items will be scanned as follows:
1 With the scanner in stand, pass the item to be scanned within 11 inches of the scan window.
The scanner will read the barcode of the item (same as above).
2 With the scanner removed from the stand, point the scanner at the barcode of the item to be
scanned.
3 Press CodeGate on the back of the scanner. The scanner reads the barcode of the item.