MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021 Page 35
Programming the Honeywell MS3780 Fusion Scanner
Sheet 16
Convert UPC-A to EAN-13
When this option is chosen, the scanner will Convert UPC-A recognition to EAN-13
recognition by transmitting a leading zero before the barcode.
If Convert UPC-A to EAN-13 recognition is not supported, scanning this sheet will cause
the G-SITE system to lose all scanning ability.
This option is required when you are interfacing Envoy BOSs with G-SITE POS systems.
It is not required by Passport systems.
CAUTION
Notes: 1) Most sites must not scan this sheet.
2) For more information, refer to “Important Programming Notes” on page 7.
To Next Page
Loading...
