MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021 Page 7
Programming Information
Programming Information
Important Programming Notes
• To program the Honeywell MS3780 Fusion Scanner, scan the barcodes found in this
manual from “Sheet 1” on page 20 through “Sheet 19” on page 38.
If the scanner is connected to a Passport system, do not scan “Sheet 11” on page 30
(2400 baud rate) or “Sheet 16” on page 35 (Convert UPC-A to EAN-13). Scanning “Sheet
13” on page 32 with scanner connected to a Passport system will cause scanner
communication failure. “Sheet 18” on page 37 is for the G-SITE systems only.
CAUTION
If the G-SITE system does not interface with a Back Office System (BOS) that requires
Expanded Universal Product Code (UPC) recognition, do not scan “Sheet 15” on page 34
(Expand UPC-E to 12 digits). Scanning “Sheet 16” on page 35 when the G-SITE system
does not interface with a BOS will cause the G-SITE system to lose all scanning ability.
CAUTION
If the G-SITE system does not interface with an Envoy
®
BOS, do not scan “Sheet 16” on
page 35 (Convert UPC-A to EAN-13). Scanning “Sheet 16” on page 35 when the G-SITE
system does not interface with an Envoy BOS will cause the G-SITE system to lose all
scanning ability.
CAUTION
• Expanded UPC recognition may not be available on all systems, or may require selecting
a specific option. Use the following guidelines:
Point of Sale
(POS) System Guidelines
G-SITE The fusion scanner can be programmed for either Expanded 11-digit UPC r
ecognition and/or
Convert UPC-A to EAN-13 recognition, if supported/required by Back Office software.
• If the Back Office software is not in use, do not enable Expanded UPC
recognition or Convert
UPC-A to EAN-13 recognition.
• If Envoy Back Office software is in use, the Expanded
11-digit UPC recognition and Convert
UPC-A to EAN-13 recognition are required.
• If the Back Office software other than Envoy is in use, check with the Major Oil Comp
any
(MOC) Help Desk or Back Office software vendor to determine if Expanded UPC recognition
and/or Convert UPC-A to EAN-13 recognition is supported/required.
Passport To use Expanded UPC recognition, from Ma
nager Workstation > Pricing > Items select Expand
UPCE option.
Ensure that this option is
enabled (turned on)