What does it mean when Honeywell MS2421 razzes once and the blue LED flashes during power up?
If your Honeywell Barcode Reader razzes once and the blue LED flashes during power up, this indicates a VLD failure. Contact a customer service representative.
What to do if Honeywell Barcode Reader scans but the data transmitted to the host is incorrect?
If the Honeywell Barcode Reader scans, but the data transmitted to the host is incorrect, verify that the scanner’s data format matches what the host system requires. Also, ensure that the scanner is connected to the correct host port.
What to do if the host is receiving data from Honeywell MS2421 Barcode Reader but the data does not look correct?
If the host receives data from the Honeywell Barcode Reader but it doesn't look correct, check that the scanner and the host are configured for the same interface.
What to do if characters are being dropped by Honeywell MS2421 Barcode Reader?
If characters are being dropped by the Honeywell Barcode Reader, the intercharacter delay may need to be added to the transmitted output.
Why Honeywell Barcode Reader doesn't scan and/or beep?
The Honeywell Barcode Reader may not scan or beep because it's trying to scan a symbology that isn't enabled. UPC/EAN and Code 128 are enabled by default, so verify that the type of bar code being read has been selected. Also, the unit might be configured for a character length lock or a minimum length, and the bar code being scanned doesn't meet the criteria. Verify that the bar code falls into the configured criteria; the scanner defaults to a minimum of 4 characters for non-UPC/EAN codes.
What to do if Honeywell Barcode Reader razzes continuously on startup?
If your Honeywell Barcode Reader razzes continuously during power up, it indicates a diagnostic failure. If the unit will not function, contact a customer service representative.
Why Honeywell Barcode Reader locks up after scanning once?
If your Honeywell Barcode Reader scans a bar code but locks up after the first scan, and the blue LED stays on, it suggests that the scanner is configured to support some form of host handshaking but is not receiving the signal. If the scanner is set up to support ACK/NAK, RTS/CTS, XON/XOFF, or D/E, verify that the host cable and host are supporting the handshaking properly.
What does 3 beeps on Honeywell MS2421 Barcode Reader mean?
If your Honeywell Barcode Reader beeps 3 times during power up, it indicates a non-volatile RAM failure. If the unit will not hold the configuration, contact a customer service representative.
What does it mean if Honeywell MS2421 unit razzes once and the blue LED flashes during power up?
If the Honeywell Barcode Reader razzes once and the blue LED flashes during power up, it signifies a VLD failure. Contact a customer service representative.
What does it mean if Honeywell Barcode Reader unit razzes continuously during power up?
If the Honeywell Barcode Reader razzes continuously during power up, it indicates a diagnostic failure. Contact a customer service representative if the unit will not function.
General| Brand | Honeywell |
|---|---|
| Model | MS2421 |
| Category | Barcode Reader |
| Language | English |
To Next Page