What does it mean if Honeywell MS2421 unit razzes twice and blue LED flash during power up?
If the Honeywell Barcode Reader razzes twice and the blue LED flashes during power up, it indicates a scanner motor failure. Contact a customer service representative.
What to do if Honeywell MS2421 scans a bar code, but locks up after the first scan?
If the Honeywell Barcode Reader scans a bar code but locks up after the first scan, it may be configured to support host handshaking but isn't receiving the signal. If the scanner is set up for ACK/NAK, RTS/CTS, XON/XOFF, or D/E, verify that the host cable and host support handshaking properly.
How to troubleshoot Honeywell Barcode Reader with no LED, beep, or motor spin?
If the Honeywell Barcode Reader has no LED, beep, or motor spin, check the transformer, outlet, and the power strip to ensure power is being supplied to the scanner. Make sure the power cable is plugged into the scanner.
What does it mean if Honeywell Barcode Reader unit razzes continuously during power up?
If the Honeywell Barcode Reader razzes continuously during power up, it indicates a diagnostic failure. Contact a customer service representative if the unit will not function.
What does it mean if Honeywell MS2421 Barcode Reader unit beeps 3 times during power up?
If the Honeywell Barcode Reader beeps three times during power up, it indicates a non-volatile RAM failure. If the unit will not hold the configuration, contact a customer service representative.
Why Honeywell Barcode Reader has multiple scans upon presentation of code?
If the Honeywell Barcode Reader has multiple scans upon presentation of code, adjust the same symbol timeout for a longer time, as it may be set too short.
Why Honeywell Barcode Reader beeps at some bar codes and not for others?
If the Honeywell Barcode Reader beeps for some bar codes but not others of the same type, the print quality of the bar code may be poor. The type of printer or its settings could be the problem. Check the print mode or change the printer settings; for example, change to econo mode or high speed.
Why Honeywell MS2421 Barcode Reader powers up but does not beep?
If the Honeywell Barcode Reader powers up but doesn't beep, the beeper may be disabled, so enable the beeper. Alternatively, no volume or tone may be selected, so select a volume and a tone.
Why Honeywell Barcode Reader doesn't scan and/or beep?
The Honeywell Barcode Reader may not scan or beep because it's trying to scan a symbology that isn't enabled. UPC/EAN and Code 128 are enabled by default, so verify that the type of bar code being read has been selected. Also, the unit might be configured for a character length lock or a minimum length, and the bar code being scanned doesn't meet the criteria. Verify that the bar code falls into the configured criteria; the scanner defaults to a minimum of 4 characters for non-UPC/EAN codes.
What to do if characters are being dropped by Honeywell MS2421 Barcode Reader?
If characters are being dropped by the Honeywell Barcode Reader, the intercharacter delay may need to be added to the transmitted output.
General| Brand | Honeywell |
|---|---|
| Model | MS2421 |
| Category | Barcode Reader |
| Language | English |
To Next Page