EAS Deactivation
SW1 and SW2 are the switch banks inside the Checkpoint device that set the deactivation range. The
following is a list of Checkpoint recommended switch bank settings.
Base Model Checkpoint Recommended Switch Bank Settings
MS2421 SW1 & SW2 switches 1 and 6 set to ON
MS2422 SW1 & SW2 switches 1 and 6 set to ON
MS2431 SW1 & SW2 switches 1 and 6 set to ON
All MS2421/MS2422/MS2431 models have a connector labeled EAS In on the bottom of the unit. An optional
EAS cable (PN 52-52511 or 52-52556) available for purchase for connection between the Checkpoint device
and the MS2421/MS2422/MS2431 scanner.
Figure 25. EAS Cable Connection (Bottom of MS2421/MS2422/MS2431)
The following figure shows the location of the EAS deactivation area for the MS2421/MS2422/MS2431
scanner. It is important to pass the entire tag through this area to deactivate the security tag.
Figure 26. EAS Deactivation Area
30
To Next Page
Loading...
