14
SCANNER OPERATION
How to Use CodeGate and the Manual Activation Mode
For illustration purposes the unit’s scan pattern has been set to
single-line (menu reading) mode.
CODEGATE MANUAL ACTIVATION MODE*
*
This feature is not a default setting.
Refer to the MetroSelect
Configuration Guide for instructions
on enabling the Manual Activation
Mode.
Figure 16.
Figure 17.
Factory Defaults: In-Stand, CodeGate is not active (Amber LED is On)
Out-of-Stand, CodeGate is active (Amber LED is Off)
For information on how to change the factory defaults, refer to the
MetroSelect Configuration Guide (00-02407).
To Next Page
Loading...
