Why Honeywell Barcode Reader characters are being dropped?
If characters are being dropped by your Honeywell Barcode Reader, inter-character delay needs to be added to the transmitted output. Add some inter-character delay to the transmitted output by using the MetroSelect Single-Line Configuration Guide.
What does it mean if Honeywell ms5100 Barcode Reader beeps two times and alternately flashes the LEDs at power up?
If your Honeywell Barcode Reader beeps two times and alternately flashes the LEDs at power up, there is a ROM failure. A flash ROM upgrade is required.
General| Scanning Technology | laser |
|---|---|
| Scan Pattern | single line |
| Type | handheld |
| Connectivity Technology | Wired |
| Interface | USB |
| Operating Temperature | 32° to 104° F (0° to 40° C) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Humidity | 5% to 95% (non-condensing) |
| Drop Specification | 1.5 m (5 ft) to concrete |
| Light Source | 650 nm visible laser diode |
To Next Page