Honeywell MX7 - Factory Default Settings

Factory Default Settings
Main Tab
Port 1 Disabled
Port 2 Internal
Port 3 Disabled
Send Key Message (WEDGE) Enabled
Enable Scanner Sound Enabled
Single Scan Off
Use illumination LEDs Enabled
COM1 Tab (External serial port)
Baud Rate 9600
Stop Bits 1
Parity None
Data Bits 8
Barcode Tab
Enable Code ID None
Continuous Scan Mode Disabled
Timeout between same symbol 1 second
Vibration
Good Scan Vibration Off
Bad Scan Vibration Off
4-125