Honeywell MX7 - COM1 Tab

COM1 Tab
Start > Settings > Control Panel > Scanner > COM1
This panel sets communication parameters for any device connected to the external port.
Adjust the settings and click the OK button to save the changes. Any changes take effect immediately.
This panel does not configure the connected device. Please refer to the documentation for the external connected or wireless
device for information on configuring the device.
Note: COM default values are restored after a cold boot or operating system upgrade.COM1 does not
support 5V switchable power on Pin 9 for tethered scanners.
Integrated laser scanner default values are 9600 Baud, 8 data bits, 1 stop bit and No parity. EV-15 scanner default values are
19200 Baud, 8 data bits, 1 stop bit and No parity. If these values are changed, the default values are restored after a cold boot
or reflashing.
4-128