Honeywell Notifier AFP-3030 - Page 15

General
Notier FDX-851AUS Series CLIP intelligent
plug-in thermal detectors with integral
communication has features that surpass
conventional detectors. Point ID capability
allows each detector’s address to be set with
decade address switches, providing exact
detector locations. FDX-851AUS Series
thermal detectors use an innovative
thermistor sensing circuit to produce
xed-temperature (FDX-851) and rate-of-rise
thermal detection (FDX-851R).
These thermal detectors provide eective,
intelligent property protection in a variety of
applications. FDX-851AUS Series detectors
are compatible with Notier intelligent Fire
Alarm Control Panels.
Features
• Sleek, low-prole, stylish design
• State-of-the-art thermistor technology
for fast response
• Rate-of-rise model (FDX-851R), 8.3°C per
minute
• Factory preset at 63°C xed temperature
rating
•
Compatible with CLIP protocol systems.
• Direct dial entry of address 01-99 mode
loops
• Visible LEDs “blink” every time the unit is
addressed
• 360°-eld viewing angle of the visual
alarm indicators . LEDs blink in Normal
condition and turn on steady in Alarm
• Integral communications and built-in
device-type identication
• Remote test feature from the panel
• Built-in functional test switch activated
by external magnet
• Low standby current
• Backward-compatible
• Built-in tamper-resistant feature
• Sealed against back pressure
• Plugs into separate base for ease of
installation and maintenance. Separate
base allows interchange of photoelectric
and thermal sensors
Approvals:
CSIRO ActivFire listed to
AS 1603.2 - 1997 (afp - 2520)
FDX-851AUS Series
Thermal (Heat) Detectors
Page 1 of 2 DOC-02-133
Intelligent/Addressable Devices