800-21358 - A - 10/2015
2
Getting Started 2
This chapter contains the following sections:
• Installing the ConfigTool IP Utility, page 27
• Discovering Your Device on the Network, page 28
• Assigning a New IP Address to Your Device, page 28
• Upgrading Your Device’s Firmware, page 29
• Opening a Web Client, page 31
Installing the ConfigTool IP Utility
Before you can start using your camera, you must install the ConfigTool IP utility on your PC.
1. Insert the software CD that came with your camera into your PC’s disk drive.
2. Open the
Honeywell Config Tool
folder, and then double-click
Honeywell ConfigTool.exe
.
3. On the ConfigTool welcome screen, click
Next
.
4. Read the User License Agreement. If you agree, select
I agree
.
5. If you want, you can change the installation directory (by default, ConfigTool will be installed
in C:\Program Files). To proceed with the installation, click
Install
.
6. If the installation is successful, the message "
Installation is complete!
" appears.
Click
Enjoy Now
to open ConfigTool.
To Next Page