Honeywell Performance HBD3PR2 - Figure 2-4 Select Batch Mode; Figure 2-5 Batch Mode Screen

www.honeywell.com/security
30 | Performance Series IP Camera Software Configuration Guide
When the upgrade is complete, the device will reboot. While the device is rebooting, the
message "Device is offline: [device IP address]" appears.
To upgrade multiple devices simultaneously:
1. In ConfigTool, click Batch Mode.
Figure 2-4 Select Batch Mode
2. From the list of devices, click all of the devices that you want to upgrade, and then click
Start.
Figure 2-5 Batch Mode Screen
3. On the Batch Upgrade screen, click Open, navigate to the directory that contains the
firmware file, and then click OK.