PW-7000 Output Module (PW7K1OUT) Installation Guide, Document 800-25675V1 iii
Notices
Warnings and Cautions
Wiring methods shall be in accordance with the National Electrical Code (ANSI/
NFPA70), Canadian Electrical Code, Part I (CSA C22.1) Safety Standard for Electri-
cal Installations, local codes, and the authorities having jurisdiction.
Before installation, TURN OFF the external circuit breaker which supplies power to
the system.
Before connecting the device to the power supply, verify that the output voltage is
within specifications of the power supply.
Do not apply power to the system until after the installation has been completed.
Personal injury or death could occur, and the equipment could be damaged
beyond repair, if this precaution is not observed!
Never connect card readers to any critical entry, exit door, barrier, elevator, or gate
without providing an alternative exit in accordance with all fire and life safety
codes pertinent to the installation. These fire and safety codes vary from city to city
and you must get approval from local fire officials whenever using an electronic
product to control a door or other barrier. Use of egress buttons, for example, may
be illegal in some cities. In most applications, single action exit without prior
knowledge of what to do is a life safety requirement. Always make certain that any
required approvals are obtained in writing. DO NOT ACCEPT VERBAL APPROVALS,
BECAUSE THEY ARE NOT VALID.
Honeywell never recommends using the PW-7000 or related products for use as a
primary warning or monitoring system. Primary warning or monitoring systems
should always meet local fire and safety code requirements. The installer must also
Warning:
Before installation, TURN OFF the external circuit breaker which supplies power to the system.
Before connecting the device to the power supply, verify that the output voltage is within
specifications of the power supply.
Warning: Fire Safety and Liability Notice (Not Evaluated by UL for fire,
life safety, or burglary applications)
To Next Page
Loading...
Need help?
General
