2 RP2/RP4 User Guide
•Print Media
Honeywell offers a full line of applicable printing labels, receipt media, and
supplies.
About the Battery
Power is supplied to the printer by a rechargeable lithium ion battery. Batteries are
shipped only partially charged. The battery should be charged for a minimum of 4
hours before initial use to ensure optimal performance.
See Battery Charge Information on page 35 for further information about the bat-
tery.
Charge the Battery
1. Install the battery in the printer. Align the release tab with the same side as the
charge contacts and lock the battery into position. The latch clicks into place
when properly seated.
2. Connect the power supply to printer’s power jack.
Warning: The maximum operating temperature of the printer is 131ºF
(55°C), however the maximum operating temperature for
charging when used with a Honeywell power supply is limited
to 104ºF (40°C). Charge the printer in a location that meets this
temperature requirement.
To Next Page
Loading...
Need help?
General
