65-009
0-6
28
7800 SERIES S7800A KEYBOARD DISPLAY MODULE
Change
Password
New
Password:
000
Fig. 42. Change Password/New Password screen.
Use up/down arrows to change the numbers and left/right
arrows to move the cursor.
Press ENTER using the two ENTER buttons at the same time.
– Save
Changes
– Exit no
Save
Display
Setup-CS
ON/OFF
CS ON/OFF allows the Call Service Message to be as follows:
•
OFF
-N
o call Service Message displayed, normal 7800
SERIES lockout message displayed.
•
O
N-C
u
sto
mized Call Service Message displayed on 7800
SERIES lockout. Goes away when 7800 SERIES reset
button is
pushed-just
like a normal lockout.
• ON, Temporarily
Of
f-
Used for service technician to view
normal 7800 SERIES Lockout messages along with
diagnostic and history files. After 5 minutes, the display
goes back to the Call Service On mode.
DISPLAY Setup will appear. Enter your password if you have
changed the default password.
Fig. 43. Save Changes/Exit no Save screen.
Use down arrow to save.
New Password Is: XXX
Use ENTER to
Confirm
DISPLAY
Setup
PASSWORD: 000
Fig. 47. DlSPLAY Setup/PASSWORD screen.
Press ENTER using the two ENTER buttons at the same time.
Fig. 44. New Password ls screen.
The following message will appear:
Select
Exit
–
Confirm
–
Incorrect
Fig. 48. Select/Exit screen.
Choose Select.
Fig. 45. Confirm/lncorrect screen.
Use arrow for your selection. Choosing Confirm will take you
out of the DISPLAY Setup menu.
Press the left three buttons of the KDM for one second, then
release.
DISPLAY
Setup
Select:
CLONE
Fig. 49. DlSPLAY Setup/Select CLONE screen.
Use the down arrow to scroll through the menu choices until
CS ON/OFF appears.
DISPLAY
Setup
± P
ASSWORD
Fig. 46. DlSPLAY Setup/PASSWORD screen.
Use up/down arrows to change numbers and left/right arrows
to move the cursor to enter your new password.
Press ENTER using the two ENTER buttons at the same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose
Select and you will be in the DISPLAY Setup menu. The
DISPLAY Setup/Select PASSWORD
screen (see Fig. 41) will
appear. Press ENTER using the two ENTER buttons at the
same time.
The Select/Exit Screen (see Fig. 33) will appear. Choose Exit
and you will be out of the Setup menu again.
DISPLAY
Setup
Select: CS ON/OFF
Fig. 50. DlSPLAY Setup/Select: CS ON/OFF screen.
Press ENTER using the two ENTER buttons at the same time.
Select
Exit
Fig. 51. Select/Exit screen.
Press Down arrow to Select.
To Next Page
Loading...
