Honeywell Sensepoint XCD RFD - Page 38

Sensepoint XCD RFD Technical Manual SPXCDHMRFENU Issue 1
38
Relay Operation
Set Location
Set Temperature Unit
Check Alarm functions
Set ID
Quit
Congure relay on delay time, relay off delay
time and latch/non-latch
Set location (or TAG number)
Change temperature display unit.
°C (Celsius) or °F (Fahrenheit)
Simulate alarm situation to check the alarm
system without gas present at the sensor
Change ModBus slave ID, baud and parity bit
setting
(ModBus version only)
Return to Monitoring mode
Table 11: Transmitter menu descriptions