EasyManua.ls Logo

Honeywell SILENT KNIGHT SWIFT - Page 56

Honeywell SILENT KNIGHT SWIFT
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
56 SWIFT® Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000SK-E:G 4/13/2020
LED Pattern Condition Action Required
Legend
Number of blinks
LED color
Interval between blink patterns
Duration of LED state
Indicates value is approximate
Two blinks in this pattern
First blink is green. Second is yellow
7 seconds between blink patterns
Will transition to next state after
approximately 20 minutes
Example:
leddev2_4.0.wmf
7
20
M
Figure D.4 Device LED Patterns (Continued)
Battery Check: all
batteries present
Searching for mesh
(in rescue mode)
1st mesh
restructuring
Normal mode
Searching for mesh
(in formation mode)
Minimum of 6 months battery life
remaining
Mesh is formed and initializing
Device is in the mesh and may be in
trouble
Profile is assigned and device is
searching for the mesh
Profile is assigned and device is
searching for the mesh.
Tamper entry Device has just been tampered
Ensure the mesh is in rescue mode or wait for
timeout to search mesh in formation mode.
Discovered mesh Device discovered the mesh
Solid
2.5
90
3
Ensure the mesh is in formation mode
25
6
5
M
Refer to the FACP to identify the trouble and
possible resolution.
18
4
Ensure detector is seated in the base and the
module has a faceplate
Solid
6
Solid
Waiting for a profile
Pending site survey
Active/Alarm state
Battery Check:
weak
Device is in factory default mode
Device is in factory default mode and is
ready to enter site survey mode
Less than 6 months battery life left or
not all 4 batteries are present
Device has been activated
Use SWIFT Tools to assign a profile.
Ensure all 4 batteries are present or replace the
batteries
Clear the tamper condition within
1 minute to enter site survey mode
10
5
Solid
2.5
3
18
12
5
M
Normal mode Device is in the mesh
Rescue mode Device is in the mesh and looking for
lost devices
Rescue mode
Device is in the mesh, looking for lost
devices, and may be in trouble
12
3
M
Refer to the panel to identify the trouble and
possible solution
All units are in seconds. “M” indicates Minute. “V” indicates Variable.
3
Active/Alarm state Device has been activated
Replace batteries
3
Low battery cut-off Device is functioning

Table of Contents

Related product manuals