To Next Page

To Previous Page

2. Federal Communication Commission (FCC)

2.1. FCC Compliance Statement

Revision 1 SmartLine Wireless Transmitter Professional Installation Guide 5

2. Federal Communication Commission (FCC)

2.1 FCC Compliance Statement

 This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

 This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radiofrequency energy and, if not installed and

used in accordance with these instructions, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own

expense.

 Intentional or unintentional changes or modifications must not be made to the SmartLine

Wireless unless under the express consent of the party responsible for compliance. Any such

modifications could void the user’s authority to operate the equipment and will void the

manufacturer’s warranty.

2.2 Industry Canada (IC)

2.2.1 IC Compliance Statements

 To reduce potential radio interference to other users, the antenna type and its gain should be

so chosen that the equivalent isotropic radiated power (EIRP) is not more than that permitted

for successful communication.

 Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference that may

cause undesired operation of the device.

 This Class A digital apparatus complies with Canadian ICES-003.

 French: Cet appareil numérique de la classe A est conforme à la norme NMB-003 du

Canada.

2.2.2 RF Safety Statement

 To comply with FCC’s and Industry Canada’s RF exposure requirements, the following

antenna installation and device operating configurations must be satisfied.

 Remote Point-to-Multi-Point antenna(s) for this unit must be fixed and mounted on outdoor

permanent structures with a separation distance between the antenna(s) of greater than 20 cm

and a separation distance of at least 20 cm from all persons.

 Furthermore, when using integral antenna(s) the SmartLine Wireless unit must not be co-

located with any other antenna or transmitter device and have a separation distance of at least

20cm from all persons.

Honeywell STDW810 User Manual

Questions and Answers: