7. Equivalent Isotropically Radiated Power (EIRP)
7.1. EIRP LIMITS
Revision 1 SmartLine Wireless Transmitter Professional Installation Guide 15
Notes for Table 7-1:
1. The Maximum TX Power Setting values given in Table 7-1 represent the power produced by the
Radio circuit within the RF Module. These Maximum TX Power Setting values do not include
antenna gain nor do they include the losses caused by cables and connectors. When these
external gains and losses are included, then using these Maximum TX Power Setting values
ensures that the SmartLine Wireless EIRP will not exceed the maximum EIRP limits that are
given in Table 7-1.
2. The values in the above tables have been determined through agency certification testing.
3. The following shall apply for antenna type, frequency range, application/usage and
agency/country compliance:
Antenna gains above the maximum values shown shall not be used.
Cable length/loss below the minimum values shown shall not be used.
Maximum overall radio output power shown shall not be exceeded.
Maximum EIRP values shown above shall not be exceeded.
4. Industry Canada Compliance Statement: This device has been designed to operate with
the antenna types listed in this document, and having a maximum gain of 14 dBi. Antenna types
not included in this list or having a gain greater than 14 dBi are strictly prohibited for use with
this device. The required antenna impedance is 50 ohms.
To Next Page
Loading...
Need help?
General
