300
Auto
Changeover
On, Off
OFF: The user must select heating or cooling as
needed to maintain the desired indoor
temperature.
ON (Automatic): On (enabled) Allows user to
select Auto Changeover as one of the system
modes from the home screen. In auto mode, the
thermostat can control either heating or cooling to
maintain the desired
indoor temperature.
303
Auto
Differential
0 °F to 5 °F or 0.0 °C to 2.5
°C
Differential is the minimum number of degrees rise
or fall required during off cycle to switch from the
last active mode (heat or cool) to the opposite
mode when the thermostat is in auto-changeover.
Differential is NOT deadband. The deadband
temperature between when heating (or cooling)
cycles on and cycles off to maintain setpoint is not
adjustable. The thermostat uses an algorithm that
fixes deadband at 0 °F (0 ° C).
305
High Cool
Stage
Finish
Yes, No
This ISU is only displayed when the thermostat is
set to 2 cool stages. When set to YES, this feature
keeps the higher stage of the cooling equipment
running until the desired setpoint is reached.
To Next Page
Loading...
Need help?
General
