Honeywell T7350 User Manual (English)

Other manuals for Honeywell T7350

User Guide40 pages

Product Data40 pages

Installation Instructions16 pages

Features12 pages

System Engineering44 pages

Guide Specifications4 pages

Questions and Answers:

T
taylorjenniferSep 10, 2025
What to do if the Honeywell T7350 Thermostat temperature display is incorrect?
- R
  Rodney GallowaySep 10, 2025
  If the temperature display is incorrect, there are a few potential causes: * The room temperature display may have been recalibrated. Use the PDA configuration software to recalibrate it as needed. * The thermostat might be configured for either Fahrenheit or Celsius display. Press both the Run Schedule and Copy buttons, then reconfigure the display. * The thermostat could be in a bad location. Try relocating the thermostat. * If the display shows three dashes and a degree sign, the T7350 is set for remote sensing, and the sensor is either missing, or the circuit is open or shorted.
N
Nicole WilsonSep 12, 2025
How to unlock temperature settings on Honeywell Thermostat?
- S
  Shannon CoxSep 12, 2025
  If you cannot adjust the temperature settings on your Honeywell Thermostat, it could be due to several reasons: * You may have reached the upper or lower temperature limits. Heating limits are between 40 to 90°F (7 to 31°C), and cooling limits are between 45 to 99°F (9 to 37°C). * Occupied setpoint temperature range stops might be configured. Use a PDA to check the setpoint stops and reconfigure them if needed. * The keypad might be locked. If 'LOCKED' appears when you press a key, either use a PDA (Set, Display) to unlock the keypad, or press both the Run Schedule and Copy buttons to change the keypad lock level.
M
melanie10Sep 13, 2025
Why is my Honeywell Thermostat temperature display incorrect?
- C
  christopherwalkerSep 13, 2025
  If the temperature display on your Honeywell Thermostat is incorrect, it could be due to a few reasons: * The room temperature display might have been recalibrated. Use the PDA configuration software to recalibrate it as desired. * The thermostat might be configured for either °F or °C display. Press both the Run Schedule and Copy buttons, then reconfigure the display. * The thermostat might be in a bad location. Relocate the thermostat. * The display might show three dashes and a degree sign, indicating all systems are shut down. This means the T7350 is set for remote sensing, and the sensor is either missing, or the circuit is open or shorted.