To Next PageTo Next Page
Need help?Do you have a question about the Honeywell TB3026B and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | TB3026B |
| Category | Thermostat |
| Language | English |
Honeywell's BACnet FF is a configurable, intelligent sensor-controller for various HVAC applications.
Read instructions, check ratings, ensure trained installer, and verify operation.
Proper disposal of controls containing mercury is required. Contact local authorities.
Disconnect power before installation to avoid shock or equipment damage.
Install thermostat 5 ft. above floor in area with good air circulation.
Keep wiring short, avoid line voltage systems, use shielded cable, ground shield at controlled equipment.
Provides dimensions for the wallplate mounting.
Steps to position, level, mark, drill, and secure the wallplate to the wall or wiring box.
Comply with local codes, use 18-gauge wire, follow manufacturer instructions.
Do not wire with power connected to prevent shock and damage.
Connect wires, tighten screws, push excess wire, seal opening, check for shorts.
The BACnet FF communicates on a twisted-pair MS/TP LAN using EIA-485.
Details on transmission speed, cabling, segment length, devices, and repeaters for MS/TP.
Table listing terminals, labels, and their connections.
Resistors are required at each end of the segment bus for signal integrity.
Guidelines for single-point ground, avoiding double grounds, using wire nuts, and protecting exposed points.
Details on matched resistors for MS/TP segment ends and their effect on wave forms.
Typically, precision resistors in the 80-130 Ohms range yield acceptable results.
Align terminal blocks and push thermostat onto the wallplate.
Instructions for removing the thermostat from the wallplate.
Procedure to set the date and time on the thermostat's touchscreen.
Default MAC address is 0; valid range 0-127. Default device instance is 0009999.
Steps to access installer setup mode via the thermostat screen.
Instructions for setting ISU codes 800-804 for MAC address and device instance.
Example of how to set MAC address 15 and device instance 1876.
Accesses functions specific to BACnet FF installation and configuration.
A PIN can be required via AV-133 to access ISU mode.
Steps to access ISU screens, including PIN entry if required.
Using arrows to select parameters and values in ISU screens.
ISU codes 120-160 for setting Year, Month, and Day.
ISU codes 160, 280, 320, 330, 540, 640, 670 for schedule, backlight, units, DST, programs, clock format, keypad.
ISU codes 700-703 for setting room and outside temperature/humidity offsets.
ISU codes 800-804 for MS/TP MAC and BACnet Device Instance.
Steps to issue a pairing command and activate the sensor for wireless communication.
Accessing diagnostic screens for configuration and checkout of associated sensors.
Guidelines for pairing door/window sensors and PIR sensors to specific numbers.
Activating the sensor to be paired after initiating the pairing process on the thermostat.
Enables querying and commanding key operating variables using data codes.
Key sequence to enter field service mode, with optional PIN requirement.
Procedure to set field service codes using up/down arrows on the touchscreen.
Details on 24VAC power supply, half-wave rectifier, and load ratings.
Specifications for universal inputs, internal sensors, relay outputs, and analog outputs.
Details for the wireless receiver (TB3026B-W only), including frequency and range.
Operating environment temperature and humidity ranges.
BACnet MS/TP LAN speed.
UL listing, EMC Directive, and FCC certifications.
Links and document numbers for more product information.
