INSTALLATION INSTRUCTIONS
TB7100A1000 MultiPRO™
Multispeed and Multipurpose Thermostat
APPLICATION
The TB7100A1000 MultiPRO™ Multispeed and Multipurpose Thermostat provides electronic control of 24 Vac heating
and cooling systems.
See Table 1 for a description.
Table 1. TB7100A Thermostat Description.
If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash. Dispose of properly.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of an old control.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a
hazardous condition.
2. Check ratings given in instructions and on the
product to ensure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
Feature Description
Powering Methods • Battery only
• 24 Vac only
• 24 Vac with battery backup
System Types • Conventional (1 Heat, 1 Cool stages)
• Heat Pump (up to 2 Heat,1 Cool stages)
• 2 Pipe Fan Coil
• 2 Pipe Fan Coil with Auxiliary Heat
• 4 Pipe Fan Coil
• PTAC (up to 2 Heat, 1 Cool)
Changeover Manual or automatic changeover selectable
System Setting Heat-Off-Cool-Auto
Fan Setting Auto, On
Fan Speeds Low, Medium, High
Remote Setback Remote Setback Input for occupancy sensor or DDC setback
Fan Ramping
Algorithm
VersaSpeed™ Fan Ramping Algorithm for automatic fan speed selection (fan coil and PTAC
applications)
To Next Page
Need help?
General
