To Next PageTo Next Page
Need help?Do you have a question about the Honeywell TL9160AR and is the answer not in the manual?
General| Type | Programmable Thermostat |
|---|---|
| Display | Digital |
| Power Source | Hardwired |
| Programmable | Yes |
| Backlight | Yes |
| Application | Residential |
| Load | 1.5A |
| Batteries | No |
| Stages | 1 Heat |
| Weight | 0.5 lbs |
Alerts users to potential electrical shock and equipment damage during installation.
Emphasizes the necessity of installation by a qualified electrician for safety.
Lists the main steps for installing the EConnect wireless thermostat kit with page references.
Guidance on selecting the proper location for the EIM, considering distances.
Describes two methods: in a baseboard heater or in a junction box.
Detailed instructions for installing the EIM inside a baseboard heater.
Detailed instructions for installing the EIM in a junction box.
Wiring configuration for connecting several heaters to a single EIM.
Wiring configuration for connecting multiple EIMs to the same electrical circuit.
Shows how to install batteries in the thermostat, remote control, and outdoor sensor.
Procedure to start the wireless linking process via the EIM Connect button.
Detailed steps on the thermostat to link it with the EIM.
Instructions for linking additional EIMs to the existing wireless network.
Steps to link the wireless outdoor air sensor to the EIM.
Steps to link the wireless remote control to the EIM.
Procedure to exit the wireless setup mode on the EIM.
How to enter the installer setup menu for configuration options.
Guide to setting temperature units (°C/°F) and time format (12h/24h).
Procedure to configure the minimum and maximum allowable temperature setpoints.
Instructions on how to disable the anti-freeze protection feature.
Options for locking the thermostat keypad (None, Partial, All).
How to assign a zone name to identify thermostats on the remote control.
A comprehensive list of predefined zone names and their corresponding numbers.
How to turn off the Adaptive Intelligent Recovery learning function.
Instructions to change the thermostat from 7-day programmable to non-programmable.
Using the Copy function to transfer settings to other EConnect thermostats.
Procedure to test if the heater is functioning correctly after setup.
Guidance on physically mounting the thermostat using different plate options.
Instructions for mounting the outdoor sensor vertically on an exterior wall.
List of common error codes and their descriptions for troubleshooting.
How to check the wireless signal strength between the EIM and thermostat.
Steps for replacing the thermostat and linking it to the network.
Procedure for replacing and linking remote controls or outdoor sensors.
Steps for replacing a defective EIM and re-establishing wireless links.
Details on operating ranges, dimensions, electrical ratings, and part numbers.
Information regarding FCC rules, warnings, and interference statements.
Provides website and phone number for customer assistance.
