EasyManua.ls Logo

Honeywell TL9160AR - Replace Remote Control or Outdoor Sensor; Remote;Sensor Replacement Steps; Replace Equipment Interface Module (EIM); EIM Replacement and Re-linking

Honeywell TL9160AR
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23 69-2474EFS—01
EConnect™ Wireless Thermostat Kit TL9160AR
Remotecontroloroutdoorsensor
Toreplacetheremotecontrolortheoutdoorsensor,installbatteriesinthenewdevice
(seepage7)andlinkittothewirelessnetwork(seepage10).
IfmorethanoneEIMarelinkedtothesamethermostat,youcanlinktheremote
controlortheoutdoorsensorfromanyoneoftheseEIMs.
Ifyouhavemorethanonewirelessthermostat,linktheremotecontrolortheoutdoor
sensorfromoneEIMofeachofthewirelessthermostats.
Equipmentinterfacemodule(EIM)
If you have a remote control:
1 Pressandhold,forabout3seconds,theblankspace(or
arrowifpresent)inthelowerrightcornerofthescreenuntil
thedisplaychanges.
2 PressREMOVE,thenYES.
IfyouhaveonlyoneEIMlinkedtothethermostat:
RemovethedefectiveEIM,installanewone(seepages3-6)andproceedasfollows:
1 Checkifthethermostatdisplays0Driver(s)connectedasshownon
theright.Ifso,gostraighttostep5.
2 Fromthehomescreen,pressandholdtherightcenterbuttonfor5secs.
3 Press
toselectLinkandpressOK.
4 Press
toselectRemoveandpressOK.Thethermostatwilldisplay0
Driver(s)connected.
5 Followtheproceduresonpages7-11tosetupanewnetworkwiththenewEIM.
IfyouhavemorethanoneEIMlinkedtothethermostat:
FollowtheprocedurebelowtoidentifythedefectiveEIM(s)andtore-establishalllinks:
1 RemovetheantennacoverfromeachEIMinthenetworkbysqueezing
thecover(asshownbyredarrows)andpullingitout.
2 Press,for10seconds,theCONNECTbuttononeveryEIMthathasa
greenlight.RepeatthisstepuntilnoneoftheEIMshowsagreenlight.
3 Checkifthethermostatdisplays0Driver(s)connectedasshownonthe
right.Ifso,gostraighttostep7.
4 Fromthehomescreen,pressandholdtherightcenterbuttonfor5secs.
5 Press
toselectLinkandpressOK.
6 Press
toselectRemoveandpressOK.Thethermostatwilldisplay0
Driver(s)connected.
7 Followtheproceduresonpages7-11tocreateanewnetwork.You
willknowthatanEIMisdefectiveifitslightturnsredorthethermostat
displaysanerrorcodewhenyoutrytolinktheEIMtothenetwork.
ReplaceitbeforecontinuingtolinkotherEIMs.
Press here

Table of Contents

Related product manuals