Honeywell TL9160AR - Copy Settings; Copying Configuration and Schedule; System Test; Verifying Heater Operation

19 69-2474EFS—01
EConnect™ Wireless Thermostat Kit TL9160AR
Copy
Usethisfunctiontocopythecongurationsettings,theschedulesettingsorbothtoother
EConnect™wirelessthermostatsinyourhouse.Thisfunctionisavailableonlyifthe
thermostatisconnectedeithertoaremotecontroloroutdoorsensor.Thesettingsare
copiedtootherthermostatsconnectedtotheremotecontroloroutdoorsensor.
# Display Button Step
1)
Fromtheinstaller’ssetup
menu,press asneededto
selectCopyandpressOK.
2)
Press or toselect
Schedule,Congurationor
both.PressOK.
3)
Waitmayappearforseveral
minutes.WhenDONE
appears,pressExittoreturn
tohomemenu.
System test
1 FromtheHomescreen,press untilthesetpointtemperatureisabovetheroom
ambienttemperaturebyatleast2°.PressTemporary.
2 WaitforHeatOntodisplayonthethermostat.
3 Verifyiftheheaterbecomeshot.
4 PressCanceltoreturnthethermostattoitspreviousmode.