Need help?Do you have a question about the Honeywell UDC2000 and is the answer not in the manual?
General| Display | Dual 4-digit LED |
|---|---|
| Mounting | Panel Mount |
| Control Modes | On/Off |
| Input Types | Thermocouple, RTD, DC Millivolt, DC Volt, DC Milliamp |
| Output Types | Relay, SSR Driver, DC Milliamp, DC Volt |
| Power Supply | 50/60 Hz |
| Communication | RS485 |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Dimensions | 96 x 96 mm |
| Weight | 0.5 kg (1.1 lb) |
Overview of the UDC 2000 controller and manual contents.
Essential safety guidelines for operating kilns and furnaces.
Procedure for checking controller for shipping damage.
Explains the function of each key on the controller.
Defines key terms and concepts related to the controller's operation.
Lists and illustrates the controller's different Set-Up Modes.
Practical example for changing temperature units (°F to °C) using Set-Up Mode.
Explains messages shown during firing operation.
Demonstrates how to view different display messages using the DISP key.
Details messages displayed in Single Set Point mode.
Outlines the three primary firing methods: Single Set Point, SPPROG, SPRAMP.
Guide on using the factory-set 12-segment firing schedule.
Instructions for planning and creating custom firing schedules.
Explains how to use the Ramp/Soak Worksheet for schedule planning.
Step-by-step guide to inputting programmed firing schedules.
How to modify a firing schedule while it is active.
Steps for setting up a firing schedule with a delayed start.
Methods to interrupt or pause programmed firings.
Identifies signs of a power interruption during a firing.
Explains the controller's self-tuning feature for optimal performance.
How to revert or adjust factory default settings.
Addresses common error messages and operational issues.
To Next Page