Honeywell UDC2300 User Manual

UDC2300
Universal Digital Controller
Product Manual
51-52-25-98
12/00

Honeywell UDC2300 Specifications

General

Brand	Honeywell
Model	UDC2300
Category	Controller
Language	English

Summary

2 Installation

2.2 Model Number Interpretation

Explains how to interpret the controller's model number for configuration and wiring.

2.3 Preliminary Checks

2.5 Mounting

Covers physical considerations and step-by-step instructions for mounting the controller.

2.6 Wiring

Discusses electrical considerations, grounding, and circuit wiring for the controller.

2.7 Wiring Diagrams

Presents various wiring diagrams for controller connections based on model number.

3 Initial Start-up

3.2 Powering Up the Controller

3.3 Operator Interface and Key Functions

Explains the controller's displays, indicators, and function keys.

4 Configuration

4.2 Configuration Prompt Hierarchy

4.3 Configuration Procedure

Provides a step-by-step guide on how to navigate and change controller configuration settings.

4.4 Timer Set Up Group

4.5 Tuning Set Up Group

Explains how to establish tuning constants for optimal controller response.

4.6 SP Ramp Set Up Group

4.7 Accutune Set Up Group

Details the Accutune II feature for automatic calculation of PID tuning constants.

4.8 Algorithm Set Up Group

4.9 Input 1 Set Up Group

4.10 Input 2 Set Up Group

4.11 Control Set Up Group

Deals with tuning sets, setpoint source, tracking, and output limits.

4.13 Communications Set Up Group

4.14 Alarms Set Up Group

Configures alarm setpoints, types, states, and hysteresis.

5 Monitoring the Controller

5.2 Operator Interface

5.3 Entering A Security Code

Explains how to enter and use security codes for keyboard lockout.

5.4 Lockout Feature

Details the lockout feature levels to prevent unauthorized changes to parameters.

6 Operation

6.3 Start Up Procedure for Operation

Step-by-step guide for starting up the controller for operation.

6.4 Control Modes

6.6 Timer

6.7 Accutune II

Describes the autotuning feature for self-regulating and integrating processes.

6.10 Alarm Setpoints

6.11 Three Position Step Control Algorithm

6.12 Setting a Failsafe Output Value for Restart After a Power Loss

Describes how to configure a failsafe output value for controller restart after power loss.

6.13 Setting Failsafe Mode

Explains how to set the Failsafe Mode to Latching or Non-Latching.

7 Setpoint Rate/Ramp/Program Operation

7.2 Setpoint Rate

7.3 Setpoint Ramp

7.4 Setpoint Ramp/Soak Programming

8 Input Calibration

8.2 Minimum and Maximum Range Values

8.4 Input 1 Set Up Wiring

8.5 Input 1 Calibration Procedure

Step-by-step guide for calibrating the controller's Input 1.

8.6 Input 2 Set Up Wiring

8.7 Input 2 Calibration Procedure

Step-by-step guide for calibrating the controller's Input 2.

8.8 Restore Factory Calibration

9 Output Calibration

9.2 Current Proportional Output Calibration

Details the procedure for calibrating the current proportional output.

9.3 Auxiliary Output Calibration

Details the procedure for calibrating the auxiliary output.

9.4 Three Position Step Output Calibration

10 Troubleshooting/Service

10.2 Troubleshooting Aids

10.6 Controller Failure Symptoms

10.7 Troubleshooting Procedures

Lists step-by-step procedures for resolving common controller failures.