Honeywell Voyager 1450g2DHR Series - Page 38

2 - 18
Control + ASCII Mode On: The scanner sends key combinations for ASCII control characters for values 00-1F. Windows is
the preferred mode. All keyboard country codes are supported. DOS mode is a legacy mode, and it does not support all key-
board country codes. New users should use the Windows mode. Refer to Keyboard Function Relationships, page 8-1 for
CTRL+ ASCII Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII control characters for values 00-1F, but it
does not translate any prefix or suffix information.
Default = Control + ASCII Mode Off.
Turbo Mode: The scanner sends characters to a terminal faster. If the terminal drops characters, do not use Turbo Mode.
Default = Off.
Numeric Keypad Mode: Sends numeric characters as if entered from a numeric keypad. Default = Off.
Windows Mode Control + X
Mode On
* Control + X Mode Off
DOS Mode Control + X Mode On
Windows Mode Prefix/Suffix Off
Turbo Mode On
* Turbo Mode Off
Numeric Keypad Mode On
* Numeric Keypad Mode Off