MISCELLANEOUS COMMANDS
KEYPAD, SEND HELP CONDITIONS
Your system can be programmed for 3 separate “Send Help” alerts which would
send an emergency signal to your central station. See the System Reference
sheet to see which have been programmed for your system.
DURESS
Your system can be programmed to send anemergency signal to the Central
Station if you are forced to enter the premises. If you choose to include this
feature, User Code number 15 is dedicated to this function and must only be
used under a dureaa circumstance.
QUICK ON - (QUICK ARMING)
If programmed by your installer, Quick On, or Quick Arming, allows you to turn
the system onto the away mode without user code. NOTE: Turning your system
Off always requires a vatid User Code.
Press [#] then [1]
QUICK FORCED ON
If programmed by your installer, Quick Forced On allows you to turn the bu’rglar
portion of your alarm system on to the away mode, bypassing all zones that are
not ready.
Press [#] then [2]
NOTE: A va~d user code ia still required to turn the system off.
NOTE TMs feature is disabled on UL installations.
QUICK BYPASS
If you hava quick bypass programmed for your system, you will not have to use
your user code to bypass zones. The quick bypass procedure is
ZONE (l-7)
NOTE: Bypassed zones are not protected when the system is turned on. After the
bypass command has been accepted, the keypad sounds one long beep, and tha
zone tight of the zone(s) bypaaaed will slowly bhnk, or the display will show:
=
“-
NOTE: Temporary users fi.e. baby sitters, housekeepers, etc.) should not be shown the Bypass
procedure.
Page
12
To Next Page
Loading...
