FEDERAL COMMUNICATIONS COMMISSION
(FCC) STATEMENT
This equipment haa baen tested to FCC requirements and has been found acceptable for use. The FCC
requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is.
in strict accordance with the manufacturers instructions, may cause intetierence to radio and television
reception. It has been type tested and found to comply with the hmits for a class B computing device in
accordance with the specification in Subpart J Pati 15 of FCC
Rules, which are designed to provids
reasonable protection against such interference in a residential installation. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause interference to radio
or television reception, which can ba determined by turning the equipment on, the usar is encouraged to
try and correct tha intefierence by one or more of the following measures:
If using an indoor antenna, have a quality outdoor antenna installed.
Re-orient the receiving antenna until intetierence is reduced or eliminated.
Move the receiver away from any wire runs to the controllcommunicator.
Plug the controllcommunicator into a different outlet so that it and the receiver are on diffarant branch
circuits.
If necessary, the user should consult the dealer or an experienced ratioltelevieion technician for additional
suggestions.
The user or installer may find the following booklet prepared by the Federal Communication Commission
helpful: “interference HandbooW.
This booklet ia available from the U.S. Government Printing Offica, Washington, DC 20402.
The ussr shall not make any changes or modifications to the equipment unlese authorized by the
installation Inatructiona or User’s Manual. Unauthofizad changee or modifications could void the user’s
authority to operate the equipment.
TELEPHONE OPERATIONAL PROBLEMS
In the event of telephone operational problems, disconnect the control by removing the plug from the
RJ31X wall jack. We recommand that your certifiad installer demonstrate disconnecting the phones on
installation of the ayatem. Do not disconnect the phone connation inside the controVcommunicator. Doing
so will rasult in the loss of your phone tines. If the regular phone works correctly after the
contmUcommunicator has been disconnected from the phone Knas, the contmllcommunicator has a
problem and should be returned for repair. If upon disconnection of tha contro~communicator, there is still
a problem on the tine, notify the telephone company that they have a problem and raquest prompt repair
sewice. Tha user may not under any circumstances on or out of warranty) attampt any sewice or rapairs
to tha systam. It must be returned to the factory or an authorized sewice agency for all repairs. SYSTEM
TESTING
This control unit was manufactured under rigid quality standarda and compliaa with all UL
requirements for its intended use. Maintenance is best performed by your installing company with
trained sewice paraonnel.
Pags 21
—
To Next Page
Loading...
