6 - 17
UPC-A
<Default All UPC-A Settings>
UPC-A On/Off
Note: When UPC-A Off is scanned, UPC-A bar codes are transmitted as EAN-13.
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted at the end of the scanned data or not.
Default = On.
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the scanned data, but the unit can
be programmed so it will not transmit it. Default = On.
To Next Page
Loading...
