Honeywell Z-Wave Series

14
Quick Installation Guide
If your gateway/hub/controller supports configuration function, you may remotely
configure or change the default thermostat configuration parameters. For detailed table
with all available ZWave configuration parameters search for RCHT8600 series ZWave
Thermostat in the ZWave certified products section on http://ZWavealliance.org
ZWave configuration parameters
To add to include or remove to exclude the
thermostat from ZWave network, go to
thermostat MENU/ZWAVE SETUP.
• Touch Select. You will be asked to set your primary
controller to INCLUDE MODE. Please refer to
the user manual of your ZWave controller.
• After inclusion procedure has been initiated
on your ZWave controller, touch Select on the
thermostat.
• If the inclusion procedure is successful,
"INCLUDED", the node ID, and the ZWave
connected status icon appear on the screen.
If the procedure fails, “FAILED TO INCLUDE”
appears on the screen. If this happens, position
the thermostat closer to the ZWave controller and repeat the inclusion
procedure.
• Your controller will indicate whether the thermostat was successfully added to its
network. (Please refer to the user manual of your ZWave controller.)
NOTES:
• Once the thermostat is included into the ZWave network, it assumes to be
programmed from your ZWave controller and the program schedule on the
thermostat is turned OFF by default. If the thermostat is not included into the
ZWave network, then this thermostat will function as normal programmable
thermostat. For more information, see “Scheduling options” on page 17.
• Before adding the thermostat to a ZWave network, check that it does not already
belong to one. If the thermostat is included in ZWave network, it offers to
exclude. If the thermostat is excluded from ZWave network, it offers to include.
You can also check the status by viewing the Node ID located in the thermostat
MENU/DEVICE INFO. An excluded thermostat should show zero for the Node ID
(000).
• Whether you are adding the thermostat for inclusion or removing for exclusion
from ZWave network, first you have to initiate it on your ZWave controller.
Please refer to the user manual of your ZWave controller.
• For other specific tasks, such as adding the thermostat to home automation
scenes or groups, refer to the ZWave controller instructions.
• The RCHT8600 series ZWave thermostat works in the optional ZWave battery
mode or normal power mode based on its power source. The ZWave power mode
can only be changed when thermostat is NOT included in ZWave network. You
can check the power mode in the thermostat menu under MENU/DEVICE INFO.
ZWave setup
Cancel
Back Select
Back Select