Hoover Robocom 2 - Robo.com² Maintenance Procedures (Continued); Floor Brush Replacement and Drive Wheel Cleaning

* Certain Models Only
** May vary according to model
Cleaning the Floor Brushes
Clean the Floor Brushes regularly to maintain maximum cleaning performance.
Turn Robo.com² o and remove from the Charger Base Station.1.
Turn the Robo.com² over.2.
Rotate the Floor Brush assembly carefully and using scissors cut and remove any tangled threads or hair 3.
etc.
Use the Multi-purpose Cleaning Brush to remove any excess dust.4.
Replacing the Floor Brushes
Switch the Robo.com² o and turn the Robo.com² over.1.
Pull the Floor Brush Release Latch.2.
Lift the Floor Brushes Retainer.3.
Remove both Floor Brushes.4.
Clean the recess that the Floor Brushes sit.5.
Ret the new Floor Brushes, ensuring they sit correctly.6.
Close the retainer ensuring it locks.7.
GB
MAINTAINING YOUR ROBO.COM² CLEANER
Cleaning the Drive Wheels
Switch the Robo.com² o and turn the Robo.com² over.1.
Remove any dirt or hair trapped in the wheels.2.
Clean the wheels with a dry cloth.3.
Check that the wheels can rotate freely.4.
RoboCom2Manual2011__GB.indd 11 14/07/2011 13.40.12