Familiarizeyourselfwiththesehomemaintenancetasksasproperuseandcareofyourvacuumwillensure
continuedcleaningeffectiveness.
Anyotherservicingshouldbedonebyanauthorizedservicerepresentative.
Ifapplianceisnotworkingasitshould,hasbeendropped,damaged,leftoutdoors,ordroppedintowater,
returnittoaservicecenterpriortocontinuinguse.
DIRTCUP:Whento Empty
4.1 Empty the dirt cup before the dirt cup reaches
the max line (A). Place the vacuum in the upright
)osition before removing the dirt cup.
A WARNING
To reduce the risk of personal injury - Unplug
before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or
cornstarch, may seal the filter and cause a
reduction in performance. When using the
vacuum for this type of dust, empty the cup and
clean the filters often.
DIRT CUP: Howto Empty
4.2 Press dirt cup release button and pivot cup out.
4.3 Hold dirt cup over trash receptacle, push dirt cup
door release lever (A) to open dirt cup door (B).
Close dirt cup door (B). Press firmly to secure.
4.4 Place bottom of dirt cup into vacuum body
first. Pivot dirt cup into vacuum. Press down on the
dirt cup release button to secure into place.
FILTERS:When to Clean
To maintain optimal performance, filters should be
cleaned every two months under normal use.
,& WARNINGA
To reduce the risk of personal injury - Unplug
before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
Rinsable Filter: How to Clean
Remove dirt cup as described in Fig. 4.2.
4.5 Twist the dirt cup lid to open.
4.6 Remove rinsable filter.
Rinse with water for two minutes or until water
runs clear. Then squeeze out excess water. Allow
24 hours for filter to dry completely.
Replace filter.
Close lid securely by twisting dirt cup lid until it
clicks as shown in Fig. 4.5.
Replace dirt cup as described in Fig 4.4.
• IMPORTANT.
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
10