If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
return it to a service center prior to continuing use.
,& WARNINGA
To reduce the risk of personal injury - Unplug before cleaning or servicing.
PROBLEM
Vacuum won't
run
Vacuum won't
pick up
or
Low suction
Dust escaping
from vacuum
Air-Powered
Hand Tool*
brushroll won't
turn
Brushroll will
not turn
Smoky/burning
smell detected
POSSIBLECAUSE
2. No voltage in wall plug.
4.Thermal Protector activated.
POSSIBLESOLUTION
iy.
2. Check fuse or breaker in home.
6re_ j_ #_J
4. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Dirt Cup full and/or clogged. 1. Empty dirt cup - Pg. 10.
3. Rinsable filter and/or filter 3. Clean rinsable filter and or filter made
made with HEPA media is dirty, with HEPA media - Pg.10-11.
5. Broken or worn belt. 5. Replace belt - Pg.13.
2. Dirt cup not installed correctly. 2. Review dirt cup removal & replacement -
Pg. 10.
4. Rinsable and/or filter made 4. Review filter removal and cleaning - Pg.
with HEPA media not installed 10-11.
completely or missing.
2. Blockage. 2. Remove blockage.
1. Brushroll switch is off
3. Brushroll does not work.
2. Brushroll is clogged.
1.Press the brushroll on/off switch - pg 12
3. Unplug unit, wait 30 minutes - pg 4
2. Clear/remove debris from brushroll - Pg.
12-13.
Available on select models only
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
