What to do if my Horizon Hobby Toy aircraft is difficult to launch in the wind?
If your Horizon Hobby Toy aircraft is hard to launch in the wind, it might be because you're launching downwind or into a crosswind. Always launch the aircraft directly into the wind.
What to do if my Horizon Hobby Toy aircraft will not connect to transmitter after binding?
If your Horizon Hobby Toy aircraft doesn't connect to the transmitter after binding, move the powered transmitter a few feet away from the aircraft, then disconnect and reconnect the battery to the aircraft. Ensure that the aircraft and transmitter are not near any large metal objects, wireless sources, or other transmitters. If the issue persists, check the charge of the aircraft and transmitter batteries, replacing or recharging them as needed. Finally, verify that the transmitter hasn't been bound to a different model using a different DSM Protocol; if so, re-bind the aircraft to the transmitter.
What to do if aileron/rudder on my Horizon Hobby Toy are not in neutral position after adjustment?
If the aileron and/or rudder on your Horizon Hobby Toy are not in the neutral position after being properly adjusted, it might be because the model was moved during initial power on. Unplug the flight battery and reconnect it, keeping the model immobile for at least 5 seconds.
Defines terms like WARNING, CAUTION, and NOTICE used in the manual.
Specifies the minimum age for operating the model aircraft.
Lists all items included in the aircraft package.
Details key technical specifications like motor, servos, battery, and dimensions.
Describes optional modules for enhanced flight capabilities.
Provides a step-by-step guide for initial aircraft setup and preparation.
Important safety instructions for charging the flight battery.
Details the RTF Smart Technology battery and S120 charger specifications.
Explains how to use the charger and interpret its LED status indicators.
Instructions for installing batteries and low battery alarm indication.
Identifies transmitter buttons, switches, sticks, and their functions.
Explains the meaning of transmitter LED indicators and flight mode switches.
Guides on configuring transmitters for Bind-N-Fly aircraft.
Covers setting up telemetry and adjusting dual rates for control surfaces.
Detailed instructions for attaching the landing gear components.
Steps for mounting the vertical and horizontal stabilizers.
Steps to bind the transmitter and receiver for basic operation.
Notes on binding when a GPS module is installed.
Guides on installing the battery, arming the ESC, and SAFE system initialization.
Explains how to check and adjust the aircraft's center of gravity.
Verifies correct control surface response to transmitter inputs.
Advice on selecting a suitable and safe location for flying.
Instructions on how to perform a range check on the radio system.
Steps for correctly installing the propeller and spinner.
Details SMART ESC features, telemetry, and Low Voltage Cutoff (LVC).
Explains Beginner, Intermediate, and Experienced flight modes.
How to use the Panic button to recover from unstable attitudes.
How to use the elevator and throttle sticks for pitch and speed control.
How to use aileron and rudder sticks for roll and yaw.
Recommendations for new pilots seeking flight instruction.
Information on using the DXe transmitter for buddy box training.
Settings for using a buddy box with compatible transmitters.
Procedures for initiating takeoff and ground handling.
How to adjust control surface trims during flight.
Steps for mechanically setting control surface trims.
Instructions for performing a manual landing.
Guides for using optional floats for water operations.
Steps to take after completing a flight session.
Recommended hole placements for control horns and servo arms.
Solutions for common issues with the AS3X stabilization system.
Addresses common problems like no power, turning issues, and control difficulties.
Instructions for installing the LAS module into the aircraft.
How LAS assists in landing and its limitations.
Describes LAS functionality when used with a GPS module.
Steps for installing the GPS module into the aircraft's pocket.
Detailed steps for calibrating the aircraft's compass.
Explains LED indicators for compass errors and potential causes.
Steps for powering on the aircraft and acquiring a GPS signal.
Guides on setting the home location and virtual fence modes.
How to activate Holding Pattern and AutoLand modes using transmitter buttons.
Tips for flying with SAFE+ features, including wind limitations.
Describes different virtual fence modes and how to select them.
Details LED indicators for various virtual fence modes.
In-depth explanation of the Holding Pattern mode's autonomous flight.
Describes failsafe behavior and how to deactivate the GPS system.
How to activate AutoLand and manually assist the landing process.
Procedures for deactivating GPS and resolving SAFE+ GPS issues.
A table summarizing all LED indicators and their meanings.
Instructions for disassembling and assembling the propeller and motor.
Lists part numbers for replacing damaged or lost components.
Lists recommended and optional accessories for the aircraft.
Outlines the general rules for model aircraft operation according to AMA.
Details safety guidelines specific to radio-controlled model aircraft.
Explains what the product warranty covers and what it excludes.
Information on how to obtain warranty service and contact Horizon Hobby.
Compliance statements for radio transmission and directives.
Guidelines for proper disposal of electronic equipment in the EU.
Defines terms like WARNING, CAUTION, and NOTICE used in the manual.
Specifies the minimum age for operating the model aircraft.
Lists all items included in the aircraft package.
Details key technical specifications like motor, servos, battery, and dimensions.
Describes optional modules for enhanced flight capabilities.
Provides a step-by-step guide for initial aircraft setup and preparation.
Important safety instructions for charging the flight battery.
Details the RTF Smart Technology battery and S120 charger specifications.
Explains how to use the charger and interpret its LED status indicators.
Instructions for installing batteries and low battery alarm indication.
Identifies transmitter buttons, switches, sticks, and their functions.
Explains the meaning of transmitter LED indicators and flight mode switches.
Guides on configuring transmitters for Bind-N-Fly aircraft.
Covers setting up telemetry and adjusting dual rates for control surfaces.
Detailed instructions for attaching the landing gear components.
Steps for mounting the vertical and horizontal stabilizers.
Steps to bind the transmitter and receiver for basic operation.
Notes on binding when a GPS module is installed.
Guides on installing the battery, arming the ESC, and SAFE system initialization.
Explains how to check and adjust the aircraft's center of gravity.
Verifies correct control surface response to transmitter inputs.
Advice on selecting a suitable and safe location for flying.
Instructions on how to perform a range check on the radio system.
Steps for correctly installing the propeller and spinner.
Details SMART ESC features, telemetry, and Low Voltage Cutoff (LVC).
Explains Beginner, Intermediate, and Experienced flight modes.
How to use the Panic button to recover from unstable attitudes.
How to use the elevator and throttle sticks for pitch and speed control.
How to use aileron and rudder sticks for roll and yaw.
Recommendations for new pilots seeking flight instruction.
Information on using the DXe transmitter for buddy box training.
Settings for using a buddy box with compatible transmitters.
Procedures for initiating takeoff and ground handling.
How to adjust control surface trims during flight.
Steps for mechanically setting control surface trims.
Instructions for performing a manual landing.
Guides for using optional floats for water operations.
Steps to take after completing a flight session.
Recommended hole placements for control horns and servo arms.
Solutions for common issues with the AS3X stabilization system.
Addresses common problems like no power, turning issues, and control difficulties.
Instructions for installing the LAS module into the aircraft.
How LAS assists in landing and its limitations.
Describes LAS functionality when used with a GPS module.
Steps for installing the GPS module into the aircraft's pocket.
Detailed steps for calibrating the aircraft's compass.
Explains LED indicators for compass errors and potential causes.
Steps for powering on the aircraft and acquiring a GPS signal.
Guides on setting the home location and virtual fence modes.
How to activate Holding Pattern and AutoLand modes using transmitter buttons.
Tips for flying with SAFE+ features, including wind limitations.
Describes different virtual fence modes and how to select them.
Details LED indicators for various virtual fence modes.
In-depth explanation of the Holding Pattern mode's autonomous flight.
Describes failsafe behavior and how to deactivate the GPS system.
How to activate AutoLand and manually assist the landing process.
Procedures for deactivating GPS and resolving SAFE+ GPS issues.
A table summarizing all LED indicators and their meanings.
Instructions for disassembling and assembling the propeller and motor.
Lists part numbers for replacing damaged or lost components.
Lists recommended and optional accessories for the aircraft.
Outlines the general rules for model aircraft operation according to AMA.
Details safety guidelines specific to radio-controlled model aircraft.
Explains what the product warranty covers and what it excludes.
Information on how to obtain warranty service and contact Horizon Hobby.
Compliance statements for radio transmission and directives.
Guidelines for proper disposal of electronic equipment in the EU.
General| Brand | Horizon Hobby |
|---|---|
| Model | Apprentice STS E-flite |
| Category | Toy |
| Language | English |
To Next Page