EN
B
B
3 x 16mm
Tapered hex head machine
B
Scale Accessories Optional
Float Installation Optional
Install the non-functional scale antennas on the top of the wing. Insert the tab into
the slot in the plastic tting and slide it toward the tail to lock the antenna in place.
Float Assembly
The water rudder is mounted on the left oat. When the two oats are arranged
correctly, the chine rails on the edges of the oats from the step to the nose
should be on the insides of the oats.
1. Install the two cross members and the front and rear oat struts between the
left and right oats as shown.
2. Secure the assembly together using eight 3mm set screws (A).
Float Installation
1. Insert the struts into the oat slots on the bottom of the fuselage.
2. Secure the front and rear struts to the fuselage using the included brackets
and eight 3 x 16mm screws screws (B).
3. Connect the oat servo lead to the rudder extension in the fuselage. Secure the
servo wire to the rear strut with tape or zip ties.
Disassemble in reverse order.
A
A
3mm
Set screw
A
Chine
Rails
7