®
EN
6
Assembly Video
Wing Installation
We recommend watching the “Wing Installation”
chapter/section of the assembly video by
scanning this QR code or using this URL:
www.horizonhobby.cc/ApprenticeSTOLassembly.
The wing of the Apprentice STOL S 700mm is secured to the fuselage using
two thumb screws.
1. Connect the aileron servo connectors to the servo connectors coming
out of the fuselage. The left and right servos can be connected to either
connector.
IMPORTANT: Ensure the servo connectors and the Y-harness are connected
with the correct polarity. The connectors have a small tab on one side which
must align with the corresponding socket in the Y-harness connectors. In
addition, the wire colors should match between the servos and Y-harness.
2. Insert the tabs at the front of the wing into the forward fuselage, then lower
the wing into place.
IMPORTANT: Ensure the aileron servo wires are not pinched between the
wing and fuselage.
3. Insert the wing screws and secure the wing to the fuselage by tightening
the thumb screws into place.
IMPORTANT: Do not over tighten.
To Next Page
Loading...
Need help?
General
