To Next Page

To Previous Page

Turning the Transmitter ON and OFF

Slide the power button to power the transmitter ON. The LED indicator will

illuminate green when the transmitter is ON and transmitting. To power the

transmitter OFF, slide the power button to the OFF position.

Charge the Aircraft Battery

Only use an appropriate LiPo charger to charge the included LiPo Battery.

1. Connect the charger to a suitable USB-C power supply with your USB-C cable (required, not included). The charger will work with most 5V mobile power

sources or smartphone chargers with at least 1 amp of power output.

NOTICE: Charging the battery with a USB power port with less than 1 amp of power output can produce heat.

2. Connect the charge lead to the battery, noting correct polarity. Charging a fully discharged battery takes approximately 45–60 minutes. Charge times may vary

depending on the power source.

3. Remove the battery from the charger when the charging cycle is complete.

4. Remove the charger from the power supply.

CAUTION: Once charging is complete, immediately remove the battery.

Never leave a battery connected to the charger.

Charger LED Indications

RED, solid = Charging error: ensure battery is healthy and properly connected to the charger

ORANGE, solid = Charging in progress

GREEN, solid = Charging complete

ORANGE/GREEN, ashing = Charger is ready to charge