Horotec FLASHTEST - Device Operation and Testing Procedures; Powering On and Initial Setup; Unloaded Battery Voltage Measurement

7
7. SETTINGS
8. SWITCHING ON THE DEVICE
see paragraph 8.I on page 15
Whatever the used mode is, power sector (115 - 230 V) or battery, press the ON/OFF button located at the rear panel of the device to turn it on.
The following screen displays :
A. Measuring tension (V) of unloaded batteries
A1. Press the
BATTERY
key on the main menu
FLASHTEST
to measure the unloaded battery voltage (V) (non-operating).
The following screen displays :
Display of the main menu
FLASHTEST
Key
BATTERY
A. Measuring tension of unloaded batteries
B. Measuring tension of batteries under load
C. Measuring the movement supply voltage
Key
COIL
D. Measuring the coil resistance
Key
TURBO
E. Unjamming the wheel trains
Key
ACCURACY
F. Measuring (gain/loss) the stability of the rate
Key
CIRCUIT
G. Checking the correct functioning of the circuit
H. Measuring the consumption of a watch during its operation
Display of the submenu
TENSION
Display when using the GPS MSA19.108-E