8
A2. Press the
BATTERY TEST
key of the submenu
TENSION
The following screen displays :
B. Measuring tension (V) of batteries under load
B1. Press the
BATTERY
key on the main menu
FLASHTEST
to measure the battery voltage under load (V) (operating).
The following screen displays :
There are 2 possibilities to measure the voltage of an unloaded battery :
- Battery only : place the battery on the metal plate of the device.
Place the positive pole (+) of the battery on the metal plate, so the negative pole (-) will be positioned upwards. Use the black precision probe (-)
and place it on the negative pole (-) of the battery. Read the battery voltage on the screen of the device.
- Movement with battery : place the movement with the battery on the metal plate.
See the sketch below.
Display of the sub-submenu
BATTERY TEST
Display of the sub-submenu
TENSION
Illustration refers to movement ETA 955112.
Note : in this case, only the unloaded battery voltage can be measured !
Caution : we recommend to limit the duration of the battery test to avoid that the battery discharges too quickly.
Do not touch the watch batteries with your hands to avoid a redox reaction on the surface of the battery
- 0.00 V
<->
To Next Page
Loading...
