horsch AutoForce - Water Hole Mode

Water hole mode
The drill units are lifted out in water hole mode.
No coulter pressure should therefore be applied.
The PWM value is to 0 while the water hole
mode is active.
In manual mode, the display in the start screen
and the AutoForce detail screen is set to 0 kg
and shown as blue output value. All softkeys for
changing the target value are shown in grey.
5. 0
sim
km/h
kg
200
0
rpm
0
rpm
0
rpm
No
calculation of residual quantity
Normal mode, manual
5. 0
sim
km/h
kg
0
0.0 Tg/ha
VC
Ø Tg/ha
min. 0.0 Tg/ha
0.0
max. 0.0 Tg/ha
No
calculation of residual quantity
Water hole mode, manual work screen
AutoForce
0
kg
0
kg
Manual
maize
Water hole mode, AutoForce detail screen
In automatic mode, the status display of the
work screen switches to green when activating
the water hole mode, regardless of the value
on the sensors.
In the AutoForce detail screen, the display of
the target value for the coulter pressure is set
to 0 for all sections and shown as blue output
value. The softkeys for changing the target value
for the coulter pressure are shown in grey as in
manual mode.
0.0
km/h
0
1 / min
0
1 / min
0
1 / min
No
calculation of residual quantity
Water hole mode, automatic
16
17