horsch Avatar SD 40 - Type Plate


• Deviations due to technical further development reserved.
• The weight of the implement depends on the equipment; data with minimum equipment
• The permissible transport heights and transport width for road tra󰘲c may di󰘯er from country to country. Comply with
the national registration regulations.
• Implement attachment trac-
tor link arm:
III: Coupling point distances Cat. III; Pin diameter Cat. III
IV: Coupling point distances Cat. IV; Pin diameter Cat. IV
II/III: Coupling point distances Cat. II; Pin diameter Cat. III
III/IV: Coupling point distances Cat. III; Pin diameter Cat. IV
3800
2998
8290 / 326
6140 / 242
250 (Achsverschiebung)
932 / 36
1290 / 50
3800 / 150
2998 / 118
8290
6140
932
1290

The type plate with the CE-mark is located on
the frame of the machine.
Data on the type plate:
Serial number
Permissible total weight
Drawbar load (= DL)
Axle load
Machine type
Year of construction





 
   
      

 
  
20
mm / in.