Host Liberator - Upkeep & Clean-up (Freestyle)

18
Cleaning the Filters & Vacuum Cone
Turn Freestyle off. Unlatch filter
housing and swing to the side.
Use a tank vacuum to vacuum both sides of the
black and burnt orange primary filters.
Remove the separator assembly
and wipe the inside with a cloth.
Replace the separator assembly
and push down firmly for a tight
seal.
Note: If you are
cleaning where IAQ is
a concern (i.e.
healthcare facility),
clean filters elsewhere.
Flip the filter housing over and vacuum both sides
of the 3-piece filters and replace. Refer to separate
Safety & Maintenance Instructions for HEPA filter
care.
Replace the burnt orange filter,
then the black filter. Close the filter
housing and close the latches.
a
b
e
c
d
1
Upkeep & Clean-up of the Freestyle
2
Filter
h
ousing
latches
Checking the Hose for Clogs
Unplug the vacuum hose and check for any buildup of HOST or dirt.
If buildup exists, plug straight end of the vacuum hose into the vacuum connection.
With the vacuum motor on, loosen buildup from hose elbow.
a
b
c